Browsed by
Author: adminb

Avoid chipping wood when cutting

Avoid chipping wood when cutting

Plywood is a versatile wooden product used extensively in the shelving and cabinet construction because it resists deformation and shrinkage. Made of many layers of fine wood heavily pressed together alternating directions, plywood easily supports moisture and temperature fluctuations. When cutting wood, follow these easy guidelines that will protect you from splintering.

plywood

Instructions

Turn the plywood sheet upside down when using your tool for cutting wood. The face of the plywood is the side with the best finish, made for use on the exterior of your project. Because the blade of a saw cuts upward, the thin blades on top are easily chipped.

Lay 2 inches of 4-inch boards under your wood to lift it off the floor. The circular saw cuts lightly on the boards but will protect your ground. Adjust the depth of your saw to extend ¼ inch greater than the thickness of the plywood.

Use another piece of plywood as a guide to keep your circular saw straight if you need cutting help. By placing another piece of plywood and securing it with clamps, you can use the edge as a guide for long, straight cuts.

Keep doing the cut once it starts. Unless there is an emergency situation, maintaining the cut will achieve a smooth edge. Trying to restart a cut in the middle of a piece of plywood will leave uneven marks on the edge that will require extra filing and sanding.

Recruit helper when saw cutting wood on a table. Unless you are very familiar with a table saw, simply use a circular saw. A person should stand at each end of the saw and plywood sheet by their outer corners only.

Tips & Warnings

Power saws, no matter how many security features have been installed, are very dangerous. Always follow the manufacturer’s safety instructions explicitly and do not remove safety functions such as plastic protectors.

Maintaining Your Sink

Maintaining Your Sink

Whether stainless steel, stoneware, resin or porcelain, a sink requires regular cleaning. Indeed, the limestone present in the water forms a porous deposit, certainly invisible, but that will absorb the dirt and leave traces.

Maintaining a stainless steel sink

The best way to maintain a Stainless steel sink is to clean it daily with simple washing up liquid.
To remove traces of water, a dry cloth will do the trick, but you can also, if the traces resist, use alcohol or warm white vinegar.

Note: your stainless steel sink may be scratch-resistant; In this case, do not hesitate to use a scrubbing sponge to clean it.

The next thing to do is shine your sink. To do this, use soda water or a special stainless steel product, then rinse.
If the sink is dull, use a cloth dampened with alcohol to burn, rinse and dry with a soft cloth.

If you want to disinfect your sink, the irreplaceable bleach will do just fine.

When cleaning the garbage disposal make sure that you read the instructions beforehand. These products require some extra care to make sure they don’t get damaged.

Maintaining a sandstone sink

The maintenance of a sandstone sink is very simple since the surface is smooth, which prevents the dirt from seeping. Thus, on a daily basis, a few drops of dishwashing liquid are enough to keep its original appearance.

For deeper cleaning, use scouring powder, rinse thoroughly and allow to dry.

Maintaining a porcelain sink

Porcelain sinks are often white and are therefore very dirty. To remove traces of tea, coffee, tomato sauce, etc., fill the sink with very hot water and add a few drops of bleach. Leave to rest and rinse thoroughly.

Maintaining a Resin Sink

Regarding the maintenance of a resin sink, it is important not to use abrasive products such as detergents or solvents. Dish washing liquid is the best way, knowing that this type of material is not messy and very simple to clean.

Washington what’s up?

Washington what’s up?

Hey there and welcome to my blog.  My name is Bell and as you can probably guess I’m from the Washington DC. I will talk about whatever I feel like on my site so if you don’t like that then don’t bother coming ahhaha!